Ethernet Digital Wall Clock

TimeTools ethernet based digital wall clock sits directly on an IP network and obtain accurate time information from an NTP or SNTP time server. This allows the ethernet digital wall clocks to display a continuously synchronised accurate time. Therefore, all your clocks throughout your organization can show the absolute correct time and are all displaying synchronised times.

Additionally, TimeTools ethernet atomic digital wall clock devices are power-over-ethernet enabled which means they accept power through the network cable. Therefore, a mains outlet is not required in order to site a clock in a particular location, reducing installation costs.

Configuration of the device could not be simpler. All configuration is completed over the ethernet network using a telnet session. Just open a telnet session addressed to the IP address of the wall clock, log in with your username and password and then simple configuration commands can be used to configure the clock.

Fig: TimeTools Ethernet Digital Wall Clocks

Additional References:

Digital wall clock time displays
Digital wall clock freeware

Clock Digital - NTP synchronised LED time displays
Large Digital Clock LED time display
Digital clocks synchronised to servers
Large digital time clock display
LED Digital Wall Clocks using NTP
Ethernet digital wall clock timing displays

Ethernet Wall Clock
Inova digital wall clock
LED digital wall clock
Networked digital wall clock time displays
NTP synchronised digital wall clock
POE powered digital wall clock
Power-over-ethernet digital wall clock
Radio controlled wall clock systems
Synchronised wall clock displays